Search

3 results found
De-risk assessment: Additive manufacturing of soft magnetic material for satellite actuators - AMMMSA

The goals to improve mechanical and magnetic material properties for soft magnetic Ni50Fe50 specimens processed by LPBF was achieved. Tensile strength is with ~500 MPa higher than the targeted 365 MPa and close to values of conventionally processed material. Whereas, magnetic properties measured are still lower than those specified in the datasheet of PERMENORM 5000V5 material by VAC. Since the density achieved is already close to 100% it can be concluded that not only density has a strong influence on the magnetic properties.

Germany

G617-241TAgj

Zarm Technik AG
Application of MBSE to reverse-engineer OPS-SAT and improve OPS-SAT2

The main objective of the project is the reverse engineering of the OPS-SAT system, creating a model of the existing system design. The model aims to be built in a way that it is most useful for OPS-SAT engineers to understand and discuss the existing design and use this as a basis for further development of the OPS-SAT system.

Germany

20-D-S-OPS-01-b

OHB System AG
LUPIN (Lunar Lithography Manufacturing)

Nowadays, human Moon exploration, and the consequent desire to establish a permanent settlement on its surface, represents one of the most fascinating challenge to face. The permanent presence of a human outpost very far from Earth raises the problem of the huge amount of payload required for the settlement, as well as the need of rapid and in-time supply of material and spare parts useful for all the activities carried out in-situ, including the realization of medicals tools and patient-specific back-up implants.

Germany

20-D-S-TEC-03-f

OHB System AG

Filter by programme:

Filter by start year:

Filter by end year:

Filter by keywords:

Filter by contractor:

Filter by country:

Filter by application domain:

Filter by competence domain:

Filter by technology domain:

Filter by status: